CAESAR-1 Build Version 2.00.31 Build at 09:28:27 05/22/02 Base Memory 0000640 Kb Extended Memory 0523264 Kb Total Memory 0524288 Kb Auto Detecting IDE Devices[Done] Press F2 to enter System Configuration Utility WARNING - BOOT SECTOR 0 HAS CHANGED Configuring: [Bridge Controller ] Configuring: [Bridge Controller ] Configuring: [Network Controller ] Configuring: [Network Controller ] Configuring: [Bridge Controller ] Configuring: [Network Controller ] Configuring: [Network Controller ] Press F1 to Continue, Del to Load CMOS defaults 700 Mhz Pentium III /E CPU External Cache: 256K installed /boot/config: -hConsoles: serial port BIOS drive C: is disk0 BIOS 639kB/523264kB available memory FreeBSD/x86 bootstrap loader, Revision 1.1 (root@bake.isc.freebsd.org, Sun Jun 2 23:37:39 UTC 2013) /kernel text=0x894e08 data=0xdb7d4+0xa69e0 - Copyright (c) 1992-2013 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 8.4-RELEASE-p7 #0: Wed Jan 15 13:44:38 CET 2014 root@builder84.m0n0.ch:/usr/m0n0wall/build83/tmp/sys/i386/compile/M0N0WALL_G ENERIC i386 gcc version 4.2.1 20070831 patched [FreeBSD] Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Intel Pentium III (721.08-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x68a Family = 6 Model = 8 Stepping = 10 Features=0x387f9ff real memory = 541327360 (516 MB) avail memory = 489955328 (467 MB) wlan: mac acl policy registered kbd1 at kbdmux0 cryptosoft0: on motherboard pcib0 pcibus 0 on motherboard pir0: on motherboard pci0: on pcib0 $PIR: No matching entry for 0.14.INTA $PIR: No matching entry for 0.15.INTA $PIR: No matching entry for 0.15.INTB pcib1: at device 1.0 on pci0 pci1: on pcib1 pcib2: at device 0.0 on pci1 pci2: on pcib2 $PIR: No matching entry for 1.0.INTB dc0: port 0xa080-0xa0ff mem 0xd0000400-0xd00007ff irq 10 at device 4.0 on pci2 miibus0: on dc0 dcphy0: PHY 31 on miibus0 dcphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto dc0: Ethernet address: 00:a0:8e:35:a0:82 dc0: [ITHREAD] dc1: port 0xa000-0xa07f mem 0xd0000000-0xd00003ff irq 6 at device 5.0 on pci2 miibus1: on dc1 dcphy1: PHY 31 on miibus1 dcphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto dc1: Ethernet address: 00:a0:8e:35:a0:83 dc1: [ITHREAD] isab0: at device 7.0 on pci0 isa0: on isab0 atapci0: port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x37 6,0x1100-0x110f at device 7.1 on pci0 ata0: at channel 0 on atapci0 ata0: [ITHREAD] ata1: at channel 1 on atapci0 ata1: [ITHREAD] uhci0: port 0x1200-0x121f irq 11 at de vice 7.2 on pci0 uhci0: [ITHREAD] usbus0 on uhci0 piix0: port 0x1400-0x140f at device 7.3 on pci0 Timecounter "PIIX" frequency 3579545 Hz quality 0 dc2: port 0xe080-0xe0ff mem 0xf0000400-0xf00007ff irq 10 at device 13.0 on pci0 miibus2: on dc2 dcphy2: PHY 31 on miibus2 dcphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto dc2: Ethernet address: 00:a0:8e:35:a0:80 dc2: [ITHREAD] dc3: port 0xe000-0xe07f mem 0xf0000000-0xf00003ff irq 11 at device 14.0 on pci0 miibus3: on dc3 dcphy3: PHY 31 on miibus3 dcphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto dc3: Ethernet address: 00:a0:8e:35:a0:81 dc3: [ITHREAD] cbb0: irq 12 at device 15.0 on pci0 cardbus0: on cbb0 pccard0: <16-bit PCCard bus> on cbb0 cbb0: [FILTER] cbb0: Bad Vcc requested cbb1: irq 6 at device 15.1 on pci0 cardbus1: on cbb1 pccard1: <16-bit PCCard bus> on cbb1 cbb1: [FILTER] cbb1: Bad Vcc requested cpu0 on motherboard smist0: on cpu0 device_attach: smist0 attach returned 6 pmtimer0 on isa0 unknown: can't assign resources (memory) unknown: can't assign resources (port) atrtc0: at port 0x70-0x7f irq 8 pnpid PNP0b00 on isa0 atkbdc0: at port 0x60,0x64 irq 1 pnpid PNP0303 on isa0 atkbd0: irq 1 on atkbdc0 kbd0 at atkbd0 atkbd0: [GIANT-LOCKED] atkbd0: [ITHREAD] unknown: can't assign resources (irq) uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 pnpid PNP0501 on isa0 uart0: [FILTER] uart0: console (9600,n,8,1) uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 pnpid PNP0501 on isa0 uart1: [FILTER] unknown: can't assign resources (memory) unknown: can't assign resources (port) unknown: can't assign resources (irq) Timecounter "TSC" frequency 721082978 Hz quality 800 Timecounters tick every 1.000 msec IPsec: Initialized Security Association Processing. IP Filter: v4.1.34 initialized. Default = block all, Logging = enabled usbus0: 12Mbps Full Speed USB v1.0 mdad0: 61MB at ata0-master PIO4 ugen0.1: at usbus0 uhub0: on usbus0 0: Preloaded image 22241280 bytes at 0xc0e17fd4 uhub0: 2 ports with 2 removable, self powered Trying to mount root from ufs:/dev/md0 Invalid time in real time clock. Check and reset the date immediately! kern.coredump: 1 -> 0 net.enc.in.ipsec_filter_mask: 0x00000001 -> 0x00000002 Found configuration on ad0. Converting configuration... done dc0: link state changed to DOWN dc1: link state changed to DOWN dc2: link state changed to DOWN dc3: link state changed to DOWN ******************************************************************************* * None of the assigned network interfaces could be found. * * This usually happens when installing on a new system, or when moving an * * existing configuration to a different h